Thrifty - Cutils Command Qualifier

Introduction

While CumulusUtils was growing, it became clear that economising computer resources both for CPU as for the Internet usage could be economised. Especially for users on a paid line with low debit that would be useful. In that context it was decided to introduce the Thrifty qualifier to the All and Website commands. Later the qualifier was made available to all commands (single module runs).

Thrifty tries to effectively minimise what needs to be done to create the output i.e. it will not generate YADR output for years past as, once generated, the information will never change again. Every module has different methods and needs. This article describes how to invoke thrifty and what the user can expect.

This is a work in progress as user requests, new efficiency discoveries and efficiency code changes will change over time.

Note that CumulusMX itself uploads the data for the charts to the website. It is not advised to switch that off but verify you only send the data the charts you use require. The data will be the bulk of your transfers so it will count.

Operation

Thrifty is activated when placed before the command. When using it for multiple modules it can be placed anywhere on the commandline. See the following examples:

 utils/bin/cumulusutils.exe Thrifty Website       => This activates the Thrifty command qualifier on the Website generation
 utils/bin/cumulusutils.exe Thrifty All           => This activates the Thrifty command qualifier on the All modules generation
 utils/bin/cumulusutils.exe Website Thrifty       => This only runs Website, Thrifty is ignored 
 utils/bin/cumulusutils.exe YADR Records Thrifty  => This activates the Thrifty command qualifier on the named modules
 utils/bin/cumulusutils.exe Thrifty YADR Records  => This activates the Thrifty command qualifier on the named modules
 utils/bin/cumulusutils.exe YADR Thrifty Records  => This activates the Thrifty command qualifier on the named modules

Output

The Thrifty qualifier itself has no output, the output of the individual modules is limited as far as possible and as described in the Inner Working.

Inifile parameters

Thrifty has the inifile parameters as listed below. These parameters give the cycle in days of when a module is to be run. So if the user runs CumulusUtils on a daily basis and the WindGraphPeriod is three - as shown in the listing - then the WindGraphs will only be generated once every three days (this calculation is based on the daynumber in the year for that date).

[Thrifty] Top10RecordsPeriod=1 RainGraphsPeriod=1 TempGraphsPeriod=1 WindGraphsPeriod=3 MiscGraphsPeriod=1 MapsPeriod=1 SolarGraphsPeriod=3

Inner working

In this section for every module the effect of Thrifty is described and a summary is given.