Cumulus.ini (preserving history): Difference between revisions

Cumulus.ini (preserving history) (view source)

Revision as of 13:38, 7 July 2018

243 bytes added , 7 July 2018

m

→‎Davis family specific:: Made consistent with http://sandaysoft.com/forum/viewtopic.php?f=16&t=16909&sid=31d247917686b99d2b3f9fb4392aaf49&start=15#p130696

Sfws

5,838

edits

Revision as of 10:10, 18 October 2017 (view source) Sfws (talk \| contribs) m (→‎Initial Configurations: Capitialise) ← Older edit		Revision as of 13:38, 7 July 2018 (view source) Sfws (talk \| contribs) m (→‎Davis family specific:: Made consistent with http://sandaysoft.com/forum/viewtopic.php?f=16&t=16909&sid=31d247917686b99d2b3f9fb4392aaf49&start=15#p130696) Newer edit →
\|- \|VP2PeriodicDisconnectInterval=0 \|Set this in the Station Configuration Screen '''Settings''' block with the ''Discon period'' value. Causes Cumulus to disconnect for the specified number of seconds, once a minute, on the minute (or as close as possible) to allow the Weatherlink IP to connect to the Davis Weatherlink site. Set it to zero to disable, if you are not using the Weatherlink site. When the clock minute changes, Cumulus stops the current stream of data from the console, disconnects, waits for the specified number of milliseconds, to allow the Weatherlink IP to briefly connect to the Davis Weatherlink site. Cumulus then attempts to reconnect. Set it to zero to disable, if you are not using the Weatherlink site. \|- \|DavisIPResponseTime \|The length of time in milliseconds which Cumulus waits to allow a response from the console to a command (i.e. a request for any kind of data) \|- \|DavisCalcAltPress=1