88
edits
Cumulus.ini (preserving history): Difference between revisions
From Cumulus Wiki
Jump to navigationJump to search
Cumulus.ini (preserving history) (view source)
Revision as of 22:44, 29 August 2009
, 29 August 2009EWTempdiff=x.y EWpressureoffset=x.y RTdisconnectcount=60 UseWindChillCutOff=1 added to [Station] section
mNo edit summary |
m (EWTempdiff=x.y EWpressureoffset=x.y RTdisconnectcount=60 UseWindChillCutOff=1 added to [Station] section) |
||
|
*0 = meters
*1 = feet (default)
|-
|EWTempdiff=x.y
|Enter this line in the [Station] section of the Cumulus.ini to filter eroneous temperature readings from your sensor. Replace x.y with the maximum difference in degrees you are prepared to accept between successive data readings
|-
|RTdisconnectcount=60
|Option periodically disconnect the realtime FTP connection, the theory being that it will not get stuck if the servier dies, and wil keep trying to reconnect.
Enter this line in the [Station] section of the Cumulus.ini
The '60' is an example; it represents the number of realtime ftp uploads between disconnections - so 60 would give an hour if 1 minute realtime interval selected.
|-
|EWpressureoffset=x.y
|Got a pressure problem? This can occur on startup when the pressure 'offset' that Cumulus reads is garbage, so Cumulus just uses zero (so effectively you end up with your absolute pressure being recorded instead of relative pressure). There's a work around for this by telling Cumulus what offset to use, rather than reading it from the station. You specify it in cumulus.ini by adding a line to the [Station] section:
|-
|UseWindChillCutOff=1
|Wind Chill only if temperature less than 10°C rule.
*0 = Disabled (default)
*1 = Enabled, this line needs to be added in the [Station] section of the Cumulus.ini
|-
|[Web Site]
| |||
