5,838
edits
Cumulus.ini (preserving history): Difference between revisions
From Cumulus Wiki
Jump to navigationJump to search
Cumulus.ini (preserving history) (view source)
Revision as of 18:05, 1 September 2013
, 1 September 2013→Davis family specific:: Where edit settings added
m (Minor Restructuring, addition of notes re initialisation and removal of beta changes to separate page) |
m (→Davis family specific:: Where edit settings added) |
||
|
|-
|VP2TCPPort=22222
|Set this in the Station Configuration Screen VP2 TCP/IP Settings block. Comunications port used if VP type has TCP/IP selected. Default is 2222
|-
|VP2IPAddr=0.0.0.0
|Set this in the Station Configuration Screen VP2 TCP/IP Settings block. Weather station IP address if VP type has TCP/IP selected. Default is 0.0.0.0
|-
|VP2SleepInterval=x
|where x is sleepinterval in milliseconds. See note in readme.txt about VP2SleepInterval - in current release it is around line 50. This parameter (attribute=value) is added directly to the file, it does not appear on a configuration screen.
This is the period which Cumulus waits between reads of the data from Davis stations. The default is 500 ms; if you suspect that data is being missed, you could try reducing this figure. For VirtualVP users, tests revealed that VP2SleepInterval = 1100 seems to work the best. It updates every two seconds with few exceptions.
|-
|VPClosedownTime=x
|where x is the number of seconds after the start of the re-connect attempts that you want the program to close itself. This parameter (attribute=value) is added directly to the file, it does not appear on a configuration screen.
|-
|VP2PeriodicDisconnectInterval=0
|Set this in the Station Configuration Screen Settings block with the ''Discon period'' value. Causes Cumulus to disconnect for the specified number of seconds, once a minute, on the minute (or as close as possible) to allow the Weatherlink IP to connect to the Davis Weatherlink site. Set it to zero to disable, if you are not using the Weatherlink site.
|-
|DavisCalcAltPress=1
|-
|LogExtraSensors=0
|This is set in the settings frame on the Station settings screen off the configuration menu. Set this to 1 if you have additional sensors (e.g. a Davis Leaf Wetness probe) to make Cumulus read, display, and log the readings from the sensors. You don't need to select this for Solar/UV sensors.
|}
====Introduced for problems with Fine Offset family, but may be more widely applicable:====
*Note that spike removal correction may be implemented for La Crosse stations using the EW filter settings below.
| |||
