5,838
edits
Cumulus.ini (preserving history): Difference between revisions
From Cumulus Wiki
Jump to navigationJump to search
Cumulus.ini (preserving history) (view source)
Revision as of 16:01, 10 February 2021
, 10 February 2021→Spike Removal: added text re MX applying to all models
m (→Spike Removal: add text from help file) |
m (→Spike Removal: added text re MX applying to all models) |
||
|
* {{Version badge 1}} This section was written when only Cumulus 1 was available, so the parameters are listed with defaults applicable up to Cumulus 1.9.4.
**7 of the 10 spike removal parameters listed below are adjusted in the frame at the bottom of the ''Calibration'' screen, off '''Configuration''' menu, they have a prefix of EW because they were introduced for dealing with problems seen in the Fine Offset family; the corrections are only applied when Cumulus 1 is reading directly from the station at a very frequent interval, spike removal does not apply when Cumulus is re-started and is transferring observations from the station logger to the Cumulus monthly log.
**The other 3 spike removal parameters have to be entered directly in cumulus.ini, none of these ones can be set on the 'calibration' screen.
**As Cumulus 1 does not check station type before applying any of these settings, ensure for Davis stations (these do not have spike problems) the spike removal filters are set to the defaults shown below.
**However, spike removal correction may be implemented for La Crosse stations, they can have problems with their PC interface, using the same EW filter settings listed below.
*[[File:Badge vMx.png]] Please check by looking at support forum whether parameters in this section are correct for your version of MX.
** With MX, spike removal still compares successive readings from your weather station
**The difference, in MX, is that spike removal applies to all weather station types.
{| class="wikitable" border="1"
|-
| |||
