View source for SysInfo

== Introduction ==
This module has been introduced to provide for information about the running state of ''CumulusMX'' and of the System it is running on, information otherwise missing. 

The module is implemented on MS Windows and on Linux, NOT on Mac OS. For operation on Linux the user must verify whether the application lshw has been installed. If not that has to be done first with the following command: 
    apt-get install lshw

On MS Windows the command ''systeminfo'' is used which is always present.

== Operation ==
This module is included in the website. When needed as a single output the following command is given:
    utils/bin/cumulusutils.exe SysInfo
(Note that commands to CumulusUtils are case independent)

== Inifile parameters ==
The module has two inifile parameter (see [[Cumulusutils.ini|''cumulusutils.ini'']])

  [SysInfo]
  ReportWidth=700
  SystemInfoLinesToSkip=

== Inner working ==
The applications ''lshw'' or ''systeminfo'' are started and the output is edited to what is shown on the output page. Only some information is displayed, the rest is discarded. On Windows the output of the ''systeminfo'' command is displayed up to the line of the pagefile. 

Under MS Windows the user has the ability to skip lines for display by giving the inifile parameter ''SystemInfoLinesToSkip'' a value of a comma separated list of line numbers. So:
    SystemInfoLinesToSkip=1,2,3 
would skip the first three lines.

The information is displayed as is on the webpage with the HTML PRE tag.
The width of the report can be changed with the ''ReportWidth'' inifile parameter.

[[Category:CumulusUtils]]