5,838
edits
Category:Cumulus MX: Difference between revisions
m
→Installing and Running Cumulus MX: windows properties
m (→Installing and Running Cumulus MX: commas) |
m (→Installing and Running Cumulus MX: windows properties) |
||
|
After you have done this you can run CumulusMX.exe normally without Administrator rights and therefore you can create a short-cut to run MX when your PC starts (put your user name where I have put ...), the shortcut should point to T:\CumulusMX\CumulusMX.exe (where T denotes the drive on which you have installed MX as it does not need to be the same as where your operating system is):
C:\Users\...\AppData\Roaming\Microsoft\Windows\Start Menu\Programs\Startup\CumulusMX.exe
With this you might want to right click on that shortcut, select properties, then you can set the starting position for the command window, the colours and font it will use, and even choose to start minimised, amongst many other selections.
Look at your hub or router (this should have come with instructions on how to do this in your browser) and on one screen it should show what devices are connected to your LAN and wifi. Look for the IPv4 address (w.x.y.z) of the device you have installed MX on, for example 192.168.1.64. Then give your Computer a fixed address for MX user interface by finding the network card via Network and Sharing Centre (Control Panel), click on Change Adapter Settings, then Right click on Ethernet or WiFi Adapter, select Properties and in the window that opens right click on Internet Protocol Version 4 (TCP/IP 4), and select properties and on that pop up screen tell the computer to "use the following IP address and fill it out with a subnet mask of 255.255.255.0 and gateway address between 192.168.1.1 and 192.168.1.254 (depending on the address of your hub/router).
| |||