5,838
edits
MX on Linux: Difference between revisions
m
→Wireless Network
|
=== Wireless Network ===
Depending on your Pi model, it may on first boot ask you to enter your wireless network details, it may list the wireless networks it finds and ask you to choose, or you might need to use the configuration tool, or you might need to click on an icon with two red crosses.
If your Pi is headless, then use your other computer to create a new file in the boot partition of your micro-SD card, and store it in the boot directory on your micro-SD card under the name '''wpa_supplicant.conf'''. Again if you are using Windows you can create it as a text file and then replace the '''.txt''' extension with a ''.conf'' extension,
Using a text editor that won't add any unwanted control characters, add the following text using UTF-8 encoding:▼
▲
<pre>ctrl_interface=DIR=/var/run/wpa_supplicant GROUP=netdev
update_config=1
*Obviously, if you are not in United Kingdom, you will replace '''GB''' by the country code that applies to you.
*Within the first set of quotes, replace '''YourNetwork''' by whatever ''Service Set IDentifier'' is used for your wireless network. You may have typed this into your mobile phone. It may be shown on a card that slips into a slot on your hub or router, but you may have changed it from that initial setting. Whatever it is, and it can be up to 32 characters (letters, numbers, and symbols), type it within the double quotes. Some routers come with a default SSID that is the manufacturer's name,
*Within the next set of quotes, which relate to the key (or password) that protects access to your network, replace '''YourNetworkPassword''' by whatever Pre-Shared-Key (password) is used for your wireless network. You
*Most wireless networks will use Wi-Fi Protected Access (WPA) or (from 2006) Wi-Fi Protected Access II (WPA2) protocols, so '''WPA-PSK''' is correct for you. Note that your Pi is only able to use these protocols. The earlier Wired Equivalent Privacy (WEP) was officially withdrawn in 2004 as too easy to crack, so it is not supported on a new Pi.
Should you wish to set up your Pi with several network definitions, please see [https://cumulus.hosiene.co.uk/viewtopic.php?p=139422#p139422 Notes by ExperiMentor] (a contributor to the Cumulus support forum in Switzerland). If you are using your Pi headless from a Windows PC and making use of '''PuTTY''' on your PC to see the terminal screen you would see on your Pi by using SSH, I again refer you to those notes for more details, although those notes are written assuming you have bought an empty micro-SD card, you selected a particular version of the Raspberry Operating System to download and that you are installing onto a Zero W model.
=== Other configuration ===
| |||