5,838
edits
m (Restore lost section) |
m (→Read-Write parameters in the Station section: Minor restyling so ensure MX is consistent with this legacy) |
||
|-
|CalculatedDP=0
|Selected on same screen as other parameters. Simple tick or not:
* Tick (value shown as 1 in Cumulus.ini) then Cumulus will calculate wind chill from temperature and wind speed
** Note that there is a maximum temperature, and minimum wind speed, for Cumulus to make the calculation, see [[Wind_chill]] page
*1 = Enabled, Cumulus will calculate the dew point instead. This avoids the restriction in the Oregon Scientific stations where the dew point can never be below freezing point.▼
* Don't tick (value shown as 0 in Cumulus.ini) action depends on '''Calibration settings'''
▲*
** If station provides wind chill, then that will be used provided no multiplier/offsets have been specified for temperature or wind speed
|-
|CalculatedWC=0
|Selected on same screen as other parameters. Available only from version 1.8.3. Simple tick or not:
* Tick (value shown as 1 in Cumulus.ini) then Cumulus will calculate wind chill from temperature and wind speed
** Note that there is a maximum temperature, and minimum wind speed, for Cumulus to make the calculation, see [[Wind_chill]] page
* Don't tick (value shown as 0 in Cumulus.ini) action depends on '''Calibration settings'''
** If Cumulus has non-default multiplier and/or offset settings for temperature or wind speed, Cumulus will calculate wind chill
** If station provides wind chill, then that will be used provided no multiplier/offsets have been specified for temperature or wind speed
Note that some stations (Fine Offset, for example), do not make a wind chill value available to Cumulus. For these, Cumulus always calculates it.
|-
'''You should not select the previous parameter 'ConfirmClose' if you use this option.'''
|}
==== Spike Removal ====
|
edits